Method comparison

Choosing between clamp, vacuum and magnetic systems for sheet lifting.

Each sheet lifting method suits different material, surface and access conditions. This comparison helps you understand which method can be considered for your needs.

See the methods side by side.

The table is a general starting point; suitability is determined by the actual load and operating conditions.

CriterionMechanical clampVacuum lifterMagnetic lifter
Suitable materialPlates and edges that suit the clamp design; can include non-steel materials.Surfaces that allow an airtight seal; can include non-steel materials.Iron and steel materials suitable for magnetic holding.
Gripping pointPlate edge.Plate surface.Plate surface.
Surface conditionEdge condition and edge access matter.Holes, roughness and porosity affect the seal.Paint, rust, roughness and air gaps affect holding.
AccessNeeds edge access; requires side clearance in a stack.Access from the top surface.Access from the top surface.
Perforated / cut partsDepends on part geometry.Holes can reduce the contact area.Assessed by the remaining contact area.
Power and controlUsually works mechanically.Requires vacuum generation and controls that depend on system design.Depends on system type: electromagnetic, EPM or permanent magnet.

When is a magnetic solution worth considering?

  • When the material suits magnetic holdingFor iron and steel sheets.
  • When access from the top is neededIn stacks where the edges are hard to reach.
  • When plates of different sizes are handledWith adjustable module placement.
  • When working with a crane or robotWith a connection suited to your existing equipment.

Related magnetic solutions.

An adjustable handling layout for different sheet and plate lengths.

Lifting solutions that need no fixed power cable running to the load.

Systems assessed by handling direction and sheet dimensions.

Frequently asked questions

About sheet lifting methods.

Whether the material is magnetic, the contact condition of the surface, the proportion of holes and cut-outs, and access conditions are assessed together. Magnetic systems are not suitable for non-steel materials.

A clamp can be considered when the plate edge is accessible and gripping cannot be done from the surface. Clamp selection depends on plate thickness and handling direction.

QSMAGNET offers magnetic lifting and robotic magnetic gripping solutions. This comparison is designed to help you assess whether a magnetic solution suits your needs.

Let's assess your needs together.

Share your material, dimensions and working method; let’s define the right method together.