Crane and System Selection

Can a 1-Tonne Lifting Magnet Lift Any 1-Tonne Sheet?

2 min read

Can a 1-Tonne Lifting Magnet Lift Any 1-Tonne Sheet?

No. A 1-tonne label does not mean that every sheet of the same weight can be lifted under the same conditions. Material and contact conditions affect capacity, so when you ask for an assessment of the QSMAGNET magnetic sheet lifting system, share your sheet details along with the tonnage.

Same weight, different handling conditions

A thick steel part and a wide, thin plate can weigh the same. But thin material behaves differently in terms of magnetic flux and flexing. Paint, rust or surface irregularities can also increase the contact gap and reduce lifting performance.

So in the order discussion, don’t stop at “my heaviest sheet is one tonne”. If the same supply list includes thin plates, short cut pieces and coated products, list them on separate lines. Make sure the assessment is not based only on the heaviest part.

  • Record the steel grade, width, length and thickness of the material.
  • Use surface photos to show paint, rust, coatings and obvious irregularities.
  • State the handling direction and whether you need single-piece or bundle handling.
Can a 1-Tonne Lifting Magnet Lift Any 1-Tonne Sheet? – application image

Breakaway force is not working capacity

The breakaway force shown in a technical document is the separation force under specific test conditions. The permissible working load is a separate value; don’t treat breakaway force as usable lifting capacity. The model’s working load table and the stated conditions must be the basis.

When comparing quotes, send the same sheet list to every company. Ask in writing which material range is covered, which applications are excluded and the dimensions of the proposed system. That way you can see whether two quotes with the same tonnage really meet the same need. Ask for your own sheet list to be attached to the quote so the scope of the assessment can easily be compared later.

Frequently asked questions

Does buying a higher tonnage solve the problem?

Not on its own. Material thickness, contact and geometry still have to be assessed.

Can I use the horizontal capacity for vertical handling?

Not automatically. Vertical operation requires a capacity and layout defined separately by the manufacturer.

Send QSMAGNET your sheet list and surface photos. Ask for a magnetic system quote based on the real range of material you handle, not just the label tonnage.

Related articles

All articles