Laser Cutting
How Are Parts Picked from the Table After Laser and Plasma Cutting?

Unloading after cutting is planned by deciding how finished parts and the scrap skeleton will be removed. For steel parts, QSMAGNET magnetic lifting systems for laser and plasma cutting are a handling option that can be designed around the application. Whether each part can be held must be assessed separately.
A magnetic system designed around suitable parts can move several parts to the sorting area with a crane, reducing the need for manual picking.
Link the cutting plan to the lifting plan
Large plates and small connecting parts can sit on the same table. Don’t start the quote discussion with the table size alone; share your real cutting plan too. Mark which parts you want moved together and which you want separated. Let the task of the solution be defined by that expectation.
The layout of the magnetic grippers must suit the geometry and contact area of each part to be lifted. The table area or total load being within limits does not guarantee that small and narrow parts will also be held.
- Finished parts: state the size, thickness and material of the smallest and largest part.
- Scrap skeleton: show how you want it separated after cutting and where it will be set down.
- Next process: explain whether parts go to a sorting table, a pallet or another station.

Verify the temperature in plasma cutting
The permitted value for contact with a hot part depends on the model, and temperature can also affect holding force. So if handling is planned immediately after cutting, the real part temperature must be compared with the limits of the system to be selected.
Don’t leave your need at “clearing the table quickly”. Describe the order in which you want parts separated after cutting. For example, if large parts need to go to the sorting table first, show this on the cutting plan. Let the expected workflow define the scope of the sample assessment too.
Include the drop-off area in your preparation
Discuss the unloading work together with the receiving table and pallet layout. Note the points where the same parts are lifted again. Clarify at the quotation stage which job you expect from the handling system and which sorting work will remain afterwards.
Frequently asked questions
Can all parts be picked in one go?
That depends on part geometry and gripper layout; it must be verified with the cutting plan.
Can a hot part from plasma cutting be moved immediately?
Only if the real temperature is within the verified operating limits of the selected model.
Send QSMAGNET a cutting plan, the sheet thickness and the temperature at the time of handling, and request a technical assessment for a picking layout that suits your parts.
Related articles
All articlesLaser Cutting
How Is Sheet Loaded onto a Laser Cutting Machine?
When loading sheet onto a laser cutting machine, assess the material, table size and…
Read articleLaser Cutting
Vacuum or Magnetic System for Loading Sheet in Laser Cutting?
Compare vacuum and magnetic systems for laser sheet loading by material, surface and cutting…
Read articleHandling Methods
Clamp, Vacuum or Magnet? Which Is Right for Handling Steel Sheet?
Compare plate clamps, vacuum lifters and magnetic lifters for sheet handling by material, surface…
Read article


